JL Audio VX800/8i
8-kanaals klasse D versterker met geintegreerde DSP in compact formaat
100 watt RMS x 8 op 2 ohm.
Ontworpen om hoogwaardige audio te simplificeren is elke VXi versterker gecombineerd met geavanceerde NexD2™ technologie en volledige digitale geluidsl processor.
Samen met de NexD2™ technology, levert de VX800/8i full-range versterker 75 watt per kanaal op 4 ohms, of 100 watt op 2 ohm. De 8 kanalen kunnen gebrugd worden naar een krachtige 4 x 200 watt RMS
De NexD2™ full-range technology is DSP-controlled and features a reduced loop area design utilizing DirectFET™ outputs for outstanding fidelity, very low noise and exceptional efficiency. The amplifier chassis is ultra-compact, with all connections on one side, to greatly simplify installation into tight spaces.
In plaats van traditionele knoppen en schakelaars gaan alle instellingen van de vrsterker en de DSP via een PC, Tablet of Smartphone (JL Audio TüN™ Software applicatie moet wel geinstalleerd worden)
Specificaties van de JL AUDIO VX800/8i
75 Watt RMS x 8 op 4 ohm op 14.4 V
100 Watt RMS x 8 op 2 ohm op 14.4 V
200 Watt RMS x 4 op 4 ohm op 14.4 V
60 Watt RMS x 8 op 4 ohm op 12.5 V
90 Watt RMS x 8 op 2 ohm op 12.5 V
180 Watt RMS x 4 op 4 ohm op 12.5 V
JL audio VX800/8i eigenschappen
Frequency Response 12 Hz - 24 kHz (+0, -1dB)
S/N Ratio, referred to highest rated power
(Analog Inputs) 99 dB (A-weighted, 20 Hz - 20 kHz noise bandwidth)
S/N Ratio, referred to 1 W
(Analog Inputs) 80 dB (A-weighted, 20 Hz - 20 kHz noise bandwidth)
S/N Ratio, referred to highest rated power
(Digital Inputs) 101 dB (A-weighted, 20 Hz - 20 kHz noise bandwidth)
S/N Ratio, referred to 1 W
(Digital Inputs) 82 dB (A-weighted, 20 Hz - 20 kHz noise bandwidth)
Damping Factor op 4 ohm >100 / 50 Hz
Damping Factor o 2 ohm >50 / 50 Hz
THD+N ay Rated Power <1% @ 2 Ω per Ch.
Input Voltage Range at RCA Inputs: 200 mV - 16 V RMS
Min.Copper Power / Ground Wire Gauge: 4 AWG wire (20mm2 OFC)
Fuse Rating 80 A (AFS, AGU or MaxiFuse™)
Afmetingen 287 x 168 x 54mm
Gewicht 2.95 kilo
Eigenschappen DSP
Unprecedented, Onboard DSP Tuning Power
Premium, triple-core AKM® DSP with an optimized configuration, developed in collaboration with AKM®
Hi-Res audio processing at 24 bit/96 kHz
High-performance AKM® A/D and D/A converters
10 Bands of fully parametric EQ, per output channel, including pre-outs
Shelving EQ option for Band 1 and Band 10
High-Pass & Low-Pass Filters for each output channel, with selectable alignments and slopes:
Linkwitz-Riley: 12, 24, 48 dB/octave
Butterworth: 6, 12, 18, 24, 36, 48 dB/octave
Signal Delay in 0.01 millisecond steps (equivalent to 1/8-inch, 3 mm)
All-Pass Filter (Phase EQ), with variable "Q" and corner frequency
Polarity Reversal (0 or 180 deg.)
Output Level Trim in 0.1 dB steps